Product Description
Standard Features
- Float-operated, submersible, 2-pole mechanical switch and variable level, long-cycle systems available
- Corrosion-resistant, powder-coated epoxy finish
- No sheet metal parts to rust or corrode
- Stainless steel screws, switch arm, guard, and handle
- No screens to clog
- Watertight, neoprene square ring between motor and pump housing
- Solid, buoyant, polypropylene float
- Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor
- Upper and lower sleeve bearings running in bath of oil
- Entire unit pressure-tested after assembly
- Carbon and ceramic shaft seal
- Maximum temperature for effluent or dewatering: 130 °F (54 °C)
- Passes 1/2” (13 mm) spherical solids
- 1-1/2” NPT discharge
- On point: 7-1/4” (18 cm)
- Off point: 3” (8 cm)
- Major width: 10-3/32″ (26.2 cm)
- Major height: 10-1/16″ (25.6 cm)
- Watertight and dust-tight
- 1 year limited warranty
Within this series exist several distinct models. Though performance remains the same, the pumps’ material construction is what varies. What are the differences between each model? Glad you asked…
Model 55
- Bronze switch case, motor and pump housing
- Engineered thermoplastic base
- Engineered, glass-filled, plastic impeller with metal insert
- Stainless steel guard and handle
- Bronze sleeve bearings
| Motor | 3/10 HP |
| Voltage | 115 |
| Phase | 1 Ph |
| Hertz | 60 Hz |
| RPM | 1550 RPM |
| Type | Shaded pole |
| Insulation | Class B |
| Amps | 9.7 Amps |
| Operation | Automatic |
| Auto On / Off Points | 7-1/4″ / 3″ (18.4 cm / 7.6 cm) |
| Discharge Size | 1-1/2″ NPT |
| Solids Handling | 1/2″ (12 mm) spherical solids |
| Cord Length | 9′ (3 m) auto, 15′ (5 m) nonauto |
| Cord Type | UL listed, 3-wire cord and plug |
| Max Head | 19.25′ (5.9 m) |
| Max Flow Rate | 43 GPM (163 LPM) |
| Max Operating Temperature | 130 °F (54 °C) |
| Cooling | Oil filled |
| Motor Protection | Auto reset thermal overload |
| Cap | bronze |
| Motor Housing | bronze |
| Pump Housing | bronze |
| Base | engineered thermoplastic |
| Upper Bearing | Sleeve bearing |
| Lower Bearing | Sleeve bearing |
| Mechanical Seals | Carbon and ceramic |
| Impeller Type | Non-clogging vortex |
| Impeller | Plastic |
| Hardware | Stainless steel |
| Motor Shaft | AISI 1215 cold roll steel |
| Gasket | Neoprene |
